Simulation of Real and Reactive Power
Coordination Using CSC Based IPFC for
Power Quality Issues

S.Devi; V.Suvitha; E.Mageswari; M.Yuvaleela

Simulation of Real and Reactive Power Coordination Using CSC Based IPFC for Power Quality Issues

S.Devi¹, V.Suvitha², E.Mageswari³, M.Yuvaleela⁴

Assistant Professor, Dept. of EEE, Prathyusha Institute of Technology and Management, Tamilnadu, India
Assistant Professor-I, Dept. of EEE, Prathyusha Institute of Technology and Management, Tamilnadu, India
Assistant Professor-I, Dept. of EEE, Prathyusha Institute of Technology and Management, Tamilnadu, India
Assistant Professor, Dept. of EEE, Prathyusha Institute of Technology and Management, Tamilnadu, India

Related article at Pubmed, Scholar Google

Visit for more related articles at International Journal of Advanced Research in Electrical, Electronics and Instrumentation Engineering

Abstract

FACTS technologies allow for improved transmission system operation with minimal infrastructure investment, environmental impact and implementation time compared to the construction of new transmission lines. FACTS provide the needed corrections of transmission functions in order to efficiently utilize existing transmission systems and therefore minimize the gap between the stability and the thermal level. Interline Power Flow Controller(IPFC) is a Voltage Source Converter(VSC) based FACTS controller for controlling power in multi-line system located at a substation. The main aim of the IPFC is to verify the power transfer capability between two or more lines and to establish the proposed voltage regulation function. In this paper, a current source converter topology based IPFC is proposed. In this structure, the dc-side current is regulated to a value larger than the peak value of the maximum line current. The injected voltage is controlled according to the desired reactive power compensation and management active power flow for master line. The decoupled state feedback control for the injected voltage with a separated dc current control is applied to the proposed system. The proposed IPFC has been simulated using the Matlab program.

Keywords

IPFC, CSC, Linear model, non linear model

INTRODUCTION

Three main variables that can be directly controlled to impact its performance are voltage, angle and impedence. The power quality can be mainly affected by voltage sags, harmonics, voltage fluctuations and flicker and transients. The family of compensators and power flow controllers based on VSC are the Static Synchronous Series Compensator(STATCOM), the Static Synchronous Series Compensator(SSSC), the Unified Power Flow Controller(UPFC) and the Interline Power Flow Controller (IPFC). The FACTS controllers can be realized by either a voltage-source converter (VSC) or a Current Source Converter (CSC). But, in this paper, the choice of CSC over VSC because of the advantages such as since input current is maintained constant, the misfiring of switching devices or short circuit across source would not be a serious problem, the peak current of power devices is limited, large dc link filter acts as a current limiter making it easier to apply protective fuses.The IPFC has the capability to transfer real power between the compensated lines in addition to executing the independent and controllable reactive power compensation of each line. This capability makes it possible to equalize both real and reactive power flow between the lines to transfer power demand from overloaded to underloaded lines to compensate against resistive line voltage drops and the corresponding reactive line power and to increase the effectiveness of the compensating system for dynamic disturbance like transient stability, harmonics and power oscillations.In this paper, IPFC based on the current source converter topology is proposed. For simplicity, we analyse the IPFC with only two CSC, in which one CSC is called Master CSC, while the other CSC is called Slave CSC, which provides appropriate power to the Master CSC so that it can only regulate one variable.

LITERATURE SURVEY

[1]Pranesh Rao, M.L. Crow and Zhiping yang, “STATCOM Control for Power system Voltage Control Applications,” IEEE Transactions on Power Delivery, vol. 15, No. 4, October 2000, pp.1311-1317.

[2]I.yugyi, “Dynamic Compensation of AC Transmission Lines by Solid-state Synchronous Voltage Sources”, IEEE Transactions on Power Delivery, vol. 9, no.2, April 1994,p.904-911.

[3] Hingorani.N.G, Gyugyi.L, Understanding FACTS Devices, IEEE Press 2000.

[4] Laszlo Gyugyi, Kalyan K.Sen, Colin D. Schauder, “The Interline Power Flow Controller Concept: A new Approach to Power Flow Management in Transmission System,” IEEE Trans. Power Delivery,vol.14,no.3,pp.1115- 1123,1999.

SIMULATION OF REAL AND REACTIVE POWER COORDINATION OF CSC BASED IPFC

The simulation circuit diagram of a CSC based IPFC is shown in fig1. It is connected in series with the transmission lines through three single transformers. The primary side of each transformer is connected in series with the transmission line. The secondary sides of transformers are connected in Y form. The main functions of IPFC control system are dc-side current regulating and introduce proper control signals in order to exchange the required active and reactive power with AC power system.In Fig.1, transformers are modeled as a combination of an ideal transformer and R-L impedence. The series CSC injects its output voltage in the transmission line via a series coupling transformer. In this paper, we use injected voltage source model of IPFC for fundamental frequency studies in which by regulating the amplitude and angle of its output voltage it can change both the active and reactive power in the line.

The CSC can be controlled by the tri-level SPWM technique [7] in which case it behaves as a 3-phase linear power amplifier. The CSC under tri-level SPWM control can be modeled as:

TEST SYSTEM AND RESULTS

The test power system (Fig.1) which has been modeled with Matlab is consist of two identical transmission systems. The simulated power system is composed of two voltage sources at the sending and receiving ends of a transmission lines. The test system parameters are given in the Appendix

Figure 2-10 show how the system responses for Linear and non-linear loads in Master line and Slave line.

CONCLUSION

In this paper, the IPFC based on the current source converter (CSC) topology is proposed. The dynamic model of the system is derived and divided into a linear part and a nonlinear part. The linear part is controlled in an inner loop by a decoupled state feedback controller. The nonlinear part is controlled in an outer loop by a PI controller which regulates the dc side current. The steady state performance of the IPFC are evaluated using the simulation results from Matlab program.

APPENDIX

System data is referred with Pbase=25MVA, Vbase=3.3KV. The value of Ldc-30mh, f=50Hz, RL1=RL2=RL3=10Ω, LL1=LL2=LL3=30mH, RL Load = 500 Ω, 80mH.

References

Pranesh Rao, M.L. Crow and Zhiping yang, “STATCOM Control for Power system Voltage Control Applications,” IEEE Transactions on Power Delivery, vol. 15, No. 4, October 2000, pp.1311-1317.
I.yugyi, “Dynamic Compensation of AC Transmission Lines by Solid-state Synchronous Voltage Sources”, IEEE Transactions on Power Delivery, vol. 9, no.2, April 1994,p.904-911.
Hingorani.N.G, Gyugyi.L, Understanding FACTS Devices, IEEE Press 2000.
Laszlo Gyugyi, Kalyan K.Sen, Colin D. Schauder, “The Interline Power Flow Controller Concept: A new Approach to Power Flow Management in Transmission System,” IEEE Trans. Power Delivery,vol.14,no.3,pp.1115-1123,1999.
L.Gyugyi, k.k.sen, C.D.Schauder, “The Interline Power flow controller Concept: A new Approach to Power Flow Management in Transmission Systems”, IEEE/PES Summer Meeting, Paper No. PE316-PWRD-0-07-1998, San Diego,July 1998.
Jianhong Chen, Tijing T.Lie, D.M.Vilathgamuwa, “Design of an Interline Power Flow Controller”, 14th PSCC, Sevilla, Spain, June 24-28, 2002.
X.Wang, “Advances in Pulse Width Modulation Techniques”, Ph.D. Thesis, Dept. of Electrical Engineering, McGill University, March 1993.