36 / 38
Page 123
conferenceseries
.com
Volume 5, Issue 5
Res. Rev. J Mat. Sci. 2017
ISSN: 2321-6212
Advanced Materials 2017
September 07-08, 2017
September 07-08, 2017 | Edinburgh, Scotland
Advanced materials & Processing
11
th
International Conference on
A study of strain-induced martensite characteristics of austenitic stainless steels
Mitsuhiro Okayasu
Okayama University, Japan
S
tatement of the Problem: In order to understand the formation of strain-induced martensite (SIM) of austenitic stainless steels,
phase textures were investigated both before and after static and cyclic loading, namely plastic deformation is made intentionally.
Moreover, in-situ measurements of the strain-induced martensitic transformation that takes place during tensile loading at room
temperature were performed. Even in the low plastic strain regime, with loading to yield stress, the SIM transformation occurred.
However, the area fraction of the martensite formation did not increase significantly even when the sample was loaded to the ultimate
tensile strength. On the other hand, by the cyclic loading, the area fraction of the martensite formation increases significantly when
the maximum cyclic load is more than 80%UTS. In other word, the SIM formation is apparently absent when the samples are loaded
with less than 70%UTS, although those samples are fractured completely. No clear frequency effect (1Hz vs. 30Hz) is detected. With
the analysis, two different SIM characteristics were clarified following plastic deformation. The martensitic structures were obtained
in the twin deformation and slip bands. The severity of martensite formation increased with increasing C content. It was found that
martensite was formed mainly in austenitic stainless steel lacking Mo, whereas a high Mo content led to a strong martensite structure,
i.e., a weak martensite. The formation of martensite occurred from austenite viamartensite, and was related to the slip deformation.
The Mo element in austenitic stainless steel had high slip resistance (or stress-induced martensite transformation), due to the large
size of the Mo atom. This resulted in the creation of weak martensite. The phase structures of the strained austenitic stainless steels
were interpreted using a proposed, i.e., the martensitic transformations.
mitsuhiro.okayasu@utoronto.caRes. Rev. J Mat. Sci. 2017, 5:5
DOI: 10.4172/2321-6212-C1-006